Car Door Hanger

Car Door Hanger




Door protection

Car Door Hanger

Made from heavy-gauge, cold-rolled formed track, and using large 3.75 in. (9.52 cms) diameter sealed ball bearings, our Car Door Hangers are ideal supports for heavier American elevator doors. Eccentric adjustments and slotted mounting holes make height and level adjustments simple, while large diameter reinforced nylon resin rollers reduce noise and enhance durability. Should the primary guiding means fail, sheave roller secondary safety retainers prevent door panel displacement that could occur from roller damage (as required by Code). Assemblies come complete with track, sheaves, header plate, operator support angle and all mounting hardware.

Library

Installation/Assembly Manuals

SS Single-Speed, Type “A” 22"-48" 0.74 MB PDF
2S Two-Speed, Type “A” 30"-48" 0.3 MB PDF
3S Three-Speed, Type “A” 30"-69" 0.3 MB PDF
CP Center Parting, Type “A” 30"-59" 0.3 MB PDF
2SCP Two-Speed Center Parting, Type “A” 33"-49" 0.3 MB PDF

Drilling templates with Door Clutch and Door Protection

SS Single-Speed, Type “A” 22"-48" 0.8 MB PDF
2S Two-Speed, Type “A” 30"-72" 1.0 MB PDF
3S Three-Speed, Type “A” 30"-69" 1.0 MB PDF
CP Center Parting, Type “A” 30"-59" 0.8 MB PDF
2SCP Two-Speed, Center Parting, Type “A” 33"-83" 1.3 MB PDF

Drilling Templates without Door Clutch or Door Protection

SS Single-Speed, Type “A” 22"-48" .74 MB PDF
2S Two-Speed, Type “A” 30"-72" 1.0 MB PDF
CP Center Parting, Type “A” 0.83 MB PDF

Survey Drawings

Single Speed 0.54 MB PDF
Two Speed 0.59 MB PDF
Three Speed 0.59 MB PDF
Center Parting 0.63 MB PDF
Two Speed Center Parting 0.63 MB PDF

Use this link to contact a GAL representative for more information.